kinematics: corexy max_velocity: 350 max_accel: 3000 max_z_velocity: 50 max_z_accel: 350 square_corner_velocity: 10.0 These are the highest values that klipper will allow regardless of what you may have configured in your slicer. The stock config is configured fast - so if you are facing issues - you can tweak these values lower and then increase them as you finish tuning your printer. In this section you set your maximum accelerations and velocity. Bed Screw / Tilt / Quad Gantry positions.Stepper settings (X, Y, Z(s), extruder).See ‘sensor types’ list at end of stock configuration file.The following items must be updated before the printer can function. Most keywords are lower case, make sure your phone doesn’t capitalize keywords when they shouldn’t be. While the key edits are highlighted below, you should read the entire file, and make sure you have found everything which needs your attention. Open it with your choice of editors, and go through it carefully. There are a variety of entries in printer.cfg which will need to be edited to match your particular build. Mainsail & Fluidd: nano ~/klipper_config/printer.cfg.Nano: The nano command is slightly different, depending on whether you are using Mainsail, Fluidd, or Octoprint.Mainsail: Click “Settings”, “Machine”, then on the “printer.cfg”įluidd: Click “Configuration”, then “printer.cfg”, and choose “edit” from the menu that appears.Notepad++ with the NppFTP plugin (Windows) or bbEdit (macOS) are user-friendlier alternatives. Using Nano editor through SSH is simple but not always user friendly. Mainsail & Fluidd both offer built-in printer.cfg editors. Note: There are many ways of editing the config file that vary by personal preference. Octoprint: Use a secure file transfer program (WinSCP, Cyberduck, Notepad++, NppFT, BBEdit, scp), to transfer the file to your Raspberry Pi, placing it in the folder /home/pi. Go to the “Configuration” Tab, and under “Configuration Files”, press “+”->”Upload” Go to the “Machine” tab, and under “Config Files”, press the “Upload File” buttonįluidd: Upload the file via Fluidd’s interface. Mainsail: Upload the file via Mainsail’s interface. Rename the downloaded file to printer.cfg V0 SKR mini e3 1.2 note: Not compatible with V0.1.Software Configuration Initial Voron Printer Configurationĭownload the respective Voron base configuration file from the following links:
0 kommentar(er)
